Hydraulic system A and hydraulic system B.

Precision Approach Path Indicator

-15°C

because:

-2°C per 1000 feet gives -30°C.

ISA: 15°C at sea level - 30°C = -15°C at FL150

Radiation fog forms on cloudless nights with only very light winds and high relative humidity when the cold ground cools the air above it to its dew point causing condensation (fog).

Usually occurs inland in valleys and low lying areas (as these areas tend to have more moisture) and usually occurs in a high pressure system.

At the tip

They provide at least 1000ft clearance over obstacles within 25NM of the homing facility.

Asymmetric Committal Altitude/Height is the minimum height needed to establish a positive climb whilst maintaining adequate speed for control and removal of drag during an approach to a landing.

In the Seneca at Oxford we used 200ft AGL. At this altitude when continuing for landing you selected the landing flaps (check clear runway, on speed, on altitude, landing clearance received).

You now are committed to land, single engine G/A with flaps 40 and gear down is not possible in a Seneca.

To notify the crew of the aircraft of a particular position on the IAP.

Locators have been largely replaced with Distance Measuring Equipment (DME), but they can sometimes be found associated with Outer or Middle Markers where they are referred to as Locator Outer Marker (LOM) or Locator Middle Marker (LMM).

Basic Empty Mass (BEM) is the mass of the aircraft with the basic equipment, unconsumable fluids and unusable fuel and oil.

Assuming I'm performing single pilot operations:

• power idle,

• max brakes (and reversers if available),

-maintain directional control using rudder input,

• After coming to a full stop set parking break.

• Inform ATC 'Stopping'.

• Initiate the appropriate process to diagnose the problem (ECAM, NITS DODAR, checklists....).

• When performing multi pilot operations the actions performed by me will depend with my current role: PF, PM and/or CM1 CM2.